XT-1 PRE-POST PART B- sodium chlorite solution
Disclaimer: This drug has not been found by FDA to be safe and effective, and this labeling has not been approved by FDA. For further information about unapproved drugs, click here.
XT-1 PRE POST |PART B
CAUSES SEVERE SKIN AND EYE IRRITATIONS
PREVENTION: Wash skin thoroughly after handling. Wear eye protection/ face protection.
FIRST AID / RESPONSE:
IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
IF ON SKIN(or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower. IF INHALED: Remove person to fresh air and keep
comfortable for breathing. Immediately call a POISON
CENTER/doctor. IF IN EYES: Rinse cautiously with water for several
minutes. Remove contact lenses, if present and easy to do. Continue
rinsing. Immediately call a POISON CENTER/doctor. Wash
contaminated clothing before reuse.
STORAGE: Store locked up.
DISPOSAL: Dispose of contents/ container to an approved waste disposal plant
Sodium Chlorite — 0.45%
XT-1 PRE POST is a two-part Chlorine Dioxide teat dip or spray and can be effectively used to reduce the spread of mastitis causing organisms. Recommended for pre and post milking applications.
NOTE: MUST BE MIXED PRIOR TO USE. MIX PART A & PART Bin equal parts.
CREATES CHLORINE DIOXIDE. Reaches minimum Chlorine Dioxide levels within 15 minutes of mixing , and will continue to generate minimum Chlorine Dioxide of lOOO ppm for up to 5-7 days.
Use a teat dip cup to apply. Clean dip cup just prior to use.
If cow’s teats are sore or chapped, consult a veterinarian before starting or continuing to use teat dip.
If transferred from this container to any other, make sure that the other container is thoroughly pre-cleaned and bears the proper container labeling for this product.
If product in dip cup becomes visibly dirty, discard contents and replenish with undiluted product. Do not reuse or return any unused product to the original container.
Teat Sprays can also be foamed or sprayed using recommended equipment.
Pre Dipping Use
Perform forestripping and inspect teats for clinical mastitis.
Pre-wash teats thoroughly just prior milking with appropriate udder wash solution or pre-milking teat dip. Teats should then be dried with single-service towels
Just before each cow is milked, dip, foam, or spray, each teat full-length into the teat dip or foam cup containing product.
Allow product to stand for 30 seconds.
Wipe teats dry after dipping, using single-service towels to avoid contamination of milk.
Post Dipping Use
Immediately after each milking, use product.
Dip each teat full-length into the teat dip cup containing product. Allow to air dry. Do not wipe.
If outside temperature is below freezing, allow to air dry on the teat before cow leaves the parlor.
When a cow is being dried off, the teats should be dipped in product, once a day for 3-4 days after the last milking.
Dipping should be resumed at least twice daily one week before calving.
| XT-1 PRE-POST PART B |
sodium chlorite solution solution
|Labeler — AgroChem Inc (805427700)|
|Registrant — AgroChem Inc (805427700)|
|AgroChem Inc||805427700||api manufacture, manufacture|
Revised: 07/2018 AgroChem Inc
VetLabel.com provides trustworthy package insert and label information about marketed drugs as submitted by manufacturers to the U.S. Food and Drug Administration. Package information is not reviewed or updated separately by VetLabel.com. Every individual animal healthcare product label entry contains a unique identifier which can be used to secure further details directly from the U.S. National Institutes of Health and/or the FDA.